Power source: 110V/AC~220V/AC
Power frequency: 50~60Hz
Detection range: 180°
Detection distance: 9m(<24℃)
Working temperature:-20~40℃
Ambient light: daylight and night(adjusted) Working humidity: <93%RH
Time-delay: min:8sec±3sec max:10min±2min
Installation height: 1m~1.6m
Power consumption: 0.45W(static 0.1W)
Rated Load: 800W(220V/AC~240V/AC)
Detection motion speed: 0.6~1.5m/s
The product is the new saving-energy switch adopted the good sensitivity detector, integrated circuit and SMT. It gathers automatism, convenient safe, sawing-energy and practical functions. Three detectors inside compose a wide range detection field, they utilize the infrared energy from human as control-signal source to start the load at once when human enter detection field. And they can identify day and night automatically. It is easy to install and used widely, possessing the power show and detecting show functions.
Function:
Same the right picture
1 Fixing panel hole
2 Fixing wall hole
3 Lens
4 Ambient light adjust
5 10min,5min,1min,T=10s
6 Touch-tone switch: AUTO, OFF, ON;
ØDetection field: The wide range is made up of up and down, left and right service field, the moving orientation has relationship with the sensitivity, please consider it carefully when you select the installation position;
Ø It can identify day and night automatically: This product has been adjusted to the maximum before leaving factory. But it also can be adjusted according to client’s desire;
Ø Detection indication: The indicator lamp can flash one time when the sensor receives one signal, that show the detection is regular;
Ø Time-delay is added continually: When it receives the second induction signals after the first induction, it will compute time once more on the basic of the first time-delay’s rest. (Set time)
Ø Touching detection: The sensor will start the load when human touch the touching-line;( subjoined)
Ø Time-delay is adjustable: It can be set according to the consumer’s desire. The minimum time is 8sec±3sec,the maximum time is 10min±2min;
Ø Touch-tone switch: AUTO, OFF, ON;
Installation
Ø Shut off the power;
Ø Connect the power and the load wire with the sensor according connection-wire diagram;
Ø Lift the board-face off. Fix the sensor on the selected position with bolt;
Ø Cover the board-face and screw the bolt, then you can switch on the power to test it .
Connection-wire diagram
(See the right Fig)
Product Size: