DSP-Q series professional network power amplifiers are adopted 24 Bit professional DSP audio CMOS chip. They are designed for long-distance audio system. It is preferred for gymnasium and large-scale audio system. These series power amplifiers can be adjusted manually and also can be controlled by computer. So it is very convenient for using. You can control up to 250 PCS power amplifiers by computer. The control distance can meet 1000 meters in theory (the length of the distance depends on different conditions). You can adjust the Gain, Equalizer specification, Crossover, Delay, Opposite phase, Limiter and so on for each power amplifier. You also can adjust the Stereo, Mono, Bridged and so on. You also can adjust the specification above by manual completely without connecting to the computer.
1. The amplifier has multiple built-in intelligent protection systems
The AODA DSP-Q series amplifiers integrate anti-impact function of the power’s soft start, DC output protection, long-time over-heat protection and power-on delayed function. These can speedy protect the circuit when short circuit and over loading happen, and the performance will not be intermitted.
2. The unit has built-in digital current limiter protection
Why do some sound systems always burn tweeters? This is not necessarily a problem of the tweeter units, but some are caused by the
improper selection of power amplifier. Cut the top distortion not only sound quality degradation of the power amplifier, or soprano unit killer. AODA DSP - Q series power amplifier adopts comparison circuit, input and output signal attenuation in approaching clipping to the amplifier input signal, further reducing chopped, thus protecting the expensive speaker system, this function by a switch can choose to use or not use, let users have more freedom of choice.
3. Efficient automatic variable speed cooling system
AODA DSP-Q series amplifiers have tunnel-shape automatic cooling systems, which protect the amplifiers to operate for a long time safely.
4. The unit has various input/output connectors
AODA DSP-Q series amplifiers have various input/output connectors. An amplifier has a three-position sensitivity switch for choosing
level, stereo, bridged-mono, and parallel mono. It can connect the speaker speedy by the professional SPEAKON.
5. The unit has built-in low-cut function (selection switch)
DSP-Q series power amplifiers have low-cut function inside. This function can be chosen through the selection switch on the rear panel. It is convenient for clients to use based on their requirement.