BY-68155A BASIN MIXER

Basin faucet is a kind of faucet, which is mainly installed on the basin in family bathroom, kitchen and public places. One is a wall-mounted basin faucet in which the water pipe is buried in the wall and extends from the wall. Different basin faucets have different installation methods and requirements. The following is an introduction to the installation methods of basin faucets used in different places and types.

Introduction of different basin faucet installation methods

1. Bathroom washbasin faucet installation

When we install the basin faucet in the shower and toilet, we should pay attention to measuring the installation height of the faucet. Before installation, the user is better to simulate the washing action by himself, find the height that is most suitable for the installation of the faucet, and pay attention to the diameter of the water outlet and reserve The height of the water outlet, generally the distance between the faucet and the basin is about 35 cm, and the cold and hot water pipes should be separated to maintain a distance of 15 cm. Before installation, the water pipe needs to be rinsed with clean water.

2. Single-hole basin faucet installation

When we buy a single-lever basin faucet in a shopping mall, we should pay attention to the diameter of its water outlet. Generally, the height of the upper water outlet of the reserved hard pipe water inlet is 35 cm. The installation steps are as follows:

First, take out the faucet and screw on the tightening screw.

Secondly, screw on the hot and cold water inlet pipes, which must be tightened, otherwise it may cause water leakage. If the water inlet pipe is too long, it can be cut with a tool, and the unnecessary water pipe is cut off.

Then, take out the rubber gasket and all-copper gasket, and put the gasket and gasket on.

Finally, put the fixing nut on the tightening screw and tighten it hard. It is best to use the special sleeve to tighten the nut.

3. Installation of constant temperature basin faucet

When installing a thermostatic faucet, we need to pay attention to many details. The most important point is to distinguish the position of the hot and cold water pipes. Before installation, it is best to check whether the water pipes are set to be hot on the left and cold on the right. The water pipe is connected wrongly, so as not to cause the faucet to be unable to be used normally after installation.